Installing Tac-Grips

Installing Tac-Grip grip enhancers are very simple. All you need is: Rubbing alcohol, paper towels, Tac-Grip grip enhancers, cleaning rod, and the frame of your firearm.

 First step: Clean your frame of any oil and dirt. Then let dry.

Clean and dry

Step 2: Apply Tac-Grips to your frame in the middle of the finger grooves. (shown below)

Start in the Middle for an even distribution

Step 3: Once I have placed the grips around the sides and situated it where I want, I then roll the top of the grip tape with a cleaning rod to make sure the adhesive has a firm hold on the frame.







 Step 4: Lastly, I tap and press all the edges with the flat end of the cleaning rod in order to prevent the grip from sliding around during a match.

Helpful Tip: Once you have pressed your grips on, take a hair dryer and run it in medium on the grips to help secure the adhesive to the frame.

The finished product:

Notice the edges of the grip 

Tac-Grip says to replace their grips after 4 uses. I went through 5 matches and multiple range sessions before I had to replace the grip. They are extremely easy to install, aggressive and affordable. Check them out at http://www.tac-grip.com/